 |
- Make your own on-bike video collection.
- Universal, fits all camera's and all bikes in seconds.
- Lightweight durable billet Aluminium design.
- Fully adjustable for any angle required.
- Unique
ball jointed super strong rubber suction pads.
|
|
 |
Fitting instructions
1. Ensure that the surface to be mounted on is clean and non porous.
2.
Adjust the arms to the desired angle and tighten fully.
3. Insure that your camera is fastened to
the BikeCam tightly.
4. For increased safety use Motrax Bungee straps to hold BikeCam down to surface.
5. Always remember that the user of the Motrax BikeCam assumes full esponsibility for determining the
safety and suitability of this device and liability is therefore limited to the replacement of the BikeCam
if proved to be defective in workmanship or materials.
Note:BikeCam is a registered trade mark
belonging to Motrax.
|
|
