When tying down your bike to a trailer or van, quality tie-downs are essential to ensure the vehicle
is as secure as possible. Motrax tie-downs, when used with the Motrax Barstrap, make the task simple.
|
 |
Simple, easy, and quick to use.
Adjustable upto 15 feet.
Extra strong, heat treated steel hooks.
Vinyl coated hooks to prevent scratching.
1500lb nylon webbing straps.
|
|
MTD1
Tie-down strap (single)
£5.25
BUY NOW
MTD2 Tie-down
strap (4 pack) £15.95
BUY
NOW
|
|
The ideal way to secure the front end of your motorcycle!
|
 |
Load motorcycle into van/trailer, placing the front wheel against a secure stop.
Place machine
on side/centre/paddock stand, or get a second person to hold the machine until secure.
Grasp
the two cuffs, one in each hand and pull apart far enough to slip the cuffs over each grip being careful
not to foul any switch gear or levers.
Pull down on both end loops and attach to your own tie-down
hooks, making sure that the anchor points pull down and slightly forward on to the front wheel stop.
The tie-down points should always be as far apart as possible to better triangulate the support of your
bike.
|
|
|
Warning : The user of the Motrax BarStrap assumes full responsibility for determining the safety and
suitability of this device and liability is therefore limited to the replacement of the BarStrap if proved
to be defective in workmanship or materials.
|
|
